Cars Engine 1:10
Code:HPI110660
Barcode:4944258034126
Brand:HPI

BULLET ST 3.0 RTR 2,4GHz

This item is not available in you region (United States)
Spare parts
Necessary accessories (1) Accessories (20) Spare parts (118)
G3,0 engine slide carb w/pull start
Pan head screw M5x8mm (hex socket/10pcs)
13T Clutch bell
2pcs racing clutch shoe
Clutch springs
Disk brake
Brake pads
Clutch nut
Differential case bullet
Engine mount
Diff case
Center diff housing set
54T spur gear MT/ST
Spindle/Rear Hub Carrier Set
Front hub carries (10degrees)
Chassis brace set
Rod end set
Shock parts set
Suspension arm set
Steering bellcrank set
40T diff. gear
13T input gear
Center diff.plate orange
Radio tray bullet MT/ST orange
Rear lower arm brace orange
Front lower arm brace orange
Diff case gasket (3pcs)
Shock bladder (4pcs)
Servo saver posts 5x35mm
Servo saver set
Ball 5,8x5mm (5pcs)
Steering nut 3mm (4pcs)
Flange Pipe (4pcs)
Axle 5x40mm
Gear shaft 5x29mm
Diff shaft 5x23,5mm
Cup joint (F) 4,5x18,5mm
Cup joint (R) 4,5x18,5mm
Slipper gear shaft 6x43,5mm
Drive shaft 6x72mm
Drive shaft 6x83mm
Drive shaft 6x84mm
Turnbuckle M3.5x25mm
Turnbuckle M3,5x53mm
Pin 1.7x11mm (10pcs)
Shock shaft 3x52mm
Slipper clutch hub (F)
Slipper clutch hub (R)
Slipper clutch spring 7x9x1,7mm 3 coils
Spring 13,5x63x1,2mm 11coils (2pcs)
TP. Flat Head Screw M3*14mm (10pcs)
TP. Button Head Screw M3*19mm (10pcs)
Exhaust gaskets
Cap Head Screw M2.6x14mm (10pcs)
TP. Button Head Screw M2.6*12mm (10pcs)
Slipper clutch pad (2pcs)
Flywheel
Bullet ST wheels black chrome (pr)
Ball 5.8x14mm (5pcs)
Tuned pipe set
Exhaust header set
Bullet 3,0 CVD shaft set
TP. Flat Head Screw M2.6x12mm (12pcs)
Main chassis 6061
Body mount set
Shock body set (2sets)
Front bumper set
Rear bumper set
Support parts set
Diff. gear set
3*51,8mm front inner suspension shaft (2pcs)
3*56,3mm rear inner suspension shaft (2pcs)
Diff. shaft set
3*25mm front outer suspension shaft (2pcs)
3*35,3mm rear outer suspension shaft (2pcs)
Wheel spacer set (4pcs)
Shock tower (2pcs)
Bullet ST tyres (2pcs)
Bullet MT Ammunition Tyres (2pcs)
Bullet MT Wheels Black Chrome (Pr)
Gasket for cylinder (F3,5)
Pullstart assembly (without one way bearing)
One way bearing for pullstart
Starting pin/pressure spring
Idle screw w/spring (21BB)
Uniball
Connecting rod
Cylinder/piston/connecting rod set
Under head
Crank case (black/G3,0)
Crankshaft (SG type/G3,0)
Starting shaft (G 3,0)
Back plate with o-rings and screw set
Body Pin 6mm (20pcs)
SILICON O-RING P-3(RED)(5 pcs)
Ball stud 4,8x12mm (10pcs)
o-ring P-3 (black/4pcs)
Ball bearing 5x10mm (2pcs)
Ball bearing 10x15x4mm (2pcs)
Tuning parts (7) Bodies (1)
Information
© 2024, KAVAN Europe s.r.o.